LotusTalk - The Lotus Cars Community - View Single Post - Baseline Dyno Plots. Post Your Dyno Plots here

raygr · 04-18-2007, 10:12 PM

Here is my dyno set from today. Exige S, Larini Exhaust, Daytona intake, otherwise stock (stock cat). Note the 219 hp at the wheels. Not bad for a car that is supposed to be 220 hp.

We also drilled a hole just downstream from the intercooler to measure boost pressure. For some reason, the boost reading was uneven. Not sure about that, but it does look somewhat consistent. I think the average boost reading (using an analog pressure gauge) was about 6.5 psi. Note in the first run, we did not have the boost sensor hooked up.

04-18-2007, 10:12 PM	#23 (permalink)
raygr I have 4-Wheel OCD Join Date: Oct 2005 Location: Seattle Area Posts: 371	Exige S Dyno Here is my dyno set from today. Exige S, Larini Exhaust, Daytona intake, otherwise stock (stock cat). Note the 219 hp at the wheels. Not bad for a car that is supposed to be 220 hp. We also drilled a hole just downstream from the intercooler to measure boost pressure. For some reason, the boost reading was uneven. Not sure about that, but it does look somewhat consistent. I think the average boost reading (using an analog pressure gauge) was about 6.5 psi. Note in the first run, we did not have the boost sensor hooked up. Attached Images __________________ Ray in Washington State - 06 Elise, 07 Exige S www.mentalmotoring.com Last edited by raygr : 04-19-2007 at 11:16 PM.