|
Sorry I have not posted in a bit here. I have some stupid virus that has kept me from doing much of anything all of this week. I only get sick every couple of years or so but when I do I am usually dead to the world for a while.
I have some fasteners here that I was planning on trying that look like they will match the Exige OEM ones. If there is enough interest in this a mold can be made of the final design which would lower the cost of the OEM side scoops. I could also make a fiberglass upper bracket and use the same type of clips as in the OEM version which could eliminated the need for the fins and the rubber molding.
So far Whiskey has done a great job and I plan to help him finish everything up in any way I can. I am sure when it is done it will look great.
|