FS: 2006 Exige Part-Out
Yup. I have decided to swap a Honda K motor into my Exige. So everything that is being replaced is being sold off. Motor and trans have just under 24k miles on it. Fidanza lightweight flywheel and ACT HDSS clutch have about 1k miles or so. It also has a 170degree thermostat. BOE's REV300TVS kit was installed by myself (with help from ChronosWS) two summers ago. It has a custom tune by BOE flashed onto the ECU and it runs wonderfully.
I'd rather not part out, but if I can't find someone to take the whole thing as a package I'll start dividing it up. First into larger chunks, then into smaller ones.
So the sale would look like this:
- complete long block + supercharger, harness
- throttle body, intake, alternator
- throttle assembly
- kold-fire cable
I am actually not sure what I should be asking for this setup. Figured I'd start by asking for $12,500 and see what kind of responses I get. Shipping would be on the buyer. Are people gonna immediately start throwing money at me or just ridicule? I'll post of pics of my engine bay tomorrow.
2006 ASPEN WHITE EXIGE Bone-stock Honda K24A2 + MPx90 supercharger. 322whp/271lb-ft @13psi. Build thread here.
Last edited by Butters; 02-18-2013 at 05:32 AM.