The Lotus Cars Community banner
1 - 5 of 5 Posts

·
Registered
Joined
·
6,981 Posts
Runout? I don't know of a spec, but I would imagine any more than 0.0010 or would be noticeable on these cars.

I've never heard of rotor runout being a required check for a state safety inspection before. Your state must be very strict!!!

xtn
 

·
Registered
Joined
·
6,981 Posts
I believe the minimum spec for rotor thickness is 24mm.

xtn
 

·
Registered
Joined
·
6,981 Posts
The 24.9mm figure is a misprint, left over from the S1 cars. Or so I've read on this forum many times. I believe the correct figure for S2 cars is 24mm.

xtn
 

·
Registered
Joined
·
6,981 Posts
I believe the rotors are stamped 24.0, and right or wrong they ARE stamped. I'm surprised the safety inspector doesn't know to look at the rotor itself.
 

·
Registered
Joined
·
6,981 Posts
Woooo hooooo! I got something right for once!

xtn
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top