The Lotus Cars Community banner

1 - 6 of 6 Posts

·
Registered
Joined
·
7,239 Posts
Discussion Starter #1
I've searched for "air bag light" and have not come up too well.
We've removed the airbags and stock belts, so understandably there is now an Air Bag light. I could just cover with electrical tape and forget, but I'm told this must be OK to get an inspection done.
Anyone have a patch for this?
 

·
Banned
Joined
·
7,592 Posts
you can do what my friends brother says they do at his GM dealer on the used cars when they can't get the check engine light to go off or can't get it to go off cheaply- and pull the bulb out.

Not that I'd ever buy a GM again but I certainly know I wouldn't buy one from his dealer!
 

·
Registered
Joined
·
7,239 Posts
Discussion Starter #4
Is this placed where the wires attached to the seat belt pretensioners?
I have removed airbags as well. Are resisters needed at each bag and belt site?
 

·
Registered
Joined
·
580 Posts
If you want a quick and dirty solution, just snip the wire on the cluster harness. It's documented in the wiring diagrams, as memory serves it's one of the purple ones.
 

·
Registered
Joined
·
2,206 Posts
Is this placed where the wires attached to the seat belt pretensioners?
I have removed airbags as well. Are resisters needed at each bag and belt site?
For your first question: yes, in the same logical position as the pretensioner. As for your second question: I didn't remove the airbags, so I can't help you with that.

Good luck,

Joe
 
1 - 6 of 6 Posts
Top