The Lotus Cars Community banner
1 - 20 of 35 Posts

·
Premium Member
Joined
·
29,081 Posts
MikeAR303 said:
I'm pretty sure I'll pick them up within the next year or so... I think the stock leather seats will get annoying when I'm sliding around in them in turns.
I would be really surprised to hear that someone thought they were sliding around on the seats. I noticed no sliding.
 

·
Registered
Joined
·
3,664 Posts
Randy Chase said:
I would be really surprised to hear that someone thought they were sliding around on the seats. I noticed no sliding.
I haven't been lucky enough to drive the car yet, unlike some of you, so I can't comment until I have... but when I sat in the car I did see it as a possibility.

You have to take into consideration the fact that I'm about 2/3 the size of a normal person as well ;)
 

·
Registered
Joined
·
6,301 Posts
Jon said:
Are there any US distributors for the seats and how much $?
try sector111.com
 

·
Premium Member
Joined
·
29,081 Posts
 

·
Premium Member
Joined
·
29,081 Posts
Another option coming...

From Sector 111/Blackwatch Racing
 

Attachments

·
Registered
Joined
·
1,061 Posts
Randy, is that second pic the carbon fiber seats covered in leather? The carbon ones look so damn cool, but then I remember that they are for sitting. Must get pretty uncomfy after awhile.

Edit - nevermind - I failed to read the bold black lettering.
 

·
Registered
Joined
·
6,301 Posts
I believe it is an optional insert
 

·
Supporting Vendor
Joined
·
4,461 Posts
Approx pricing:

$1k for the single skin (7.9 lbs each)
$1.5k for the twin skin (5.3 lbs each)
Stock seat weighs approx 20lbs.

Seat pads have been developed for the ReVerie seats. They are available in plain foam or covered in alcantara or leather. Here's a pic of alcantara:


Super sexy and superlight!
 

·
Premium Member
Joined
·
29,081 Posts
Oohhhh.... oh!

Was it good for you?
 

·
Supporting Vendor
Joined
·
4,461 Posts
khamai said:
Is there a harness bar available for the S2?
I believe LCU will bring in the S2 harness bar. These bars require that some plastic be cut in the trim. BlackWatch Racing is also sorting out a solution that may not require any plastic carving.
 
1 - 20 of 35 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top