The Lotus Cars Community banner
1 - 2 of 2 Posts

·
Registered
Joined
·
689 Posts
All good ideas. I use the direct connect attachment wire to make a permanent connection to the battery terminals. Then you just plug in the pig tails that are inside the boot. Switch the two light bulbs out to LED's-- a must to reduce power drain like was stated earlier. You have to have the boot lid down and latched to turn off the two lights. I filmed the lights and just set the boot lid down snug but it does not turn off the bulbs unless latched. You can just close the electric latch like RWLott showed you earlier and then just set the boot lid down snug. (If I'm going to do that I put a section of red Ribbon in the slot when I use a screwdriver to latch the latch first.) That way I won't slam the latch while it's closed and break something.
 

·
Registered
Joined
·
689 Posts
1 - 2 of 2 Posts
Top