The Lotus Cars Community banner

Bulb replacement on rear fender reflector

1487 Views 11 Replies 5 Participants Last post by  exlondoner
Hi everyone,

I've searched but can't find any threads relating to this. Basically I just purchased an Exige from out of state and went to get the silly MD state inspection done unfortunately one of the bulbs is out on the federal reflector that runs along the fender.

How does one replace this?

Thanks
1 - 12 of 12 Posts
I believe you have to remove the wheel liner to gain access.
Michael
Hi everyone,

I've searched but can't find any threads relating to this. Basically I just purchased an Exige from out of state and went to get the silly MD state inspection done unfortunately one of the bulbs is out on the federal reflector that runs along the fender.

How does one replace this?

Thanks
Thanks, this arse**** that was performing the inspection mentioned that the entire assembly had to replaced for $50~ which made no sense.

I believe you have to remove the wheel liner to gain access.
Michael
Thanks, this arse**** that was performing the inspection mentioned that the entire assembly had to replaced for $50~ which made no sense.
They're not bulbs though, they're LEDs. You can't just replace one of those, can you?
Anyone have a definitive answer?
I'd still pull the fender liner and check the electrical connector - LEDs don't usually go bad, so I'd suspect a loose connection.
There is also a conector in the trunk area for these as well.
I'd still pull the fender liner and check the electrical connector - LEDs don't usually go bad, so I'd suspect a loose connection.
A loose connector wouldn't result in only one of the three LEDs failing to light though, would it?
If the resistor was defective it would burn out the diodes.
Michael
A loose connector wouldn't result in only one of the three LEDs failing to light though, would it?
Hmmm... I didn't know there was more than one in there (guess I never paid attention).

So, no, if the light was unplugged, none would light up. :shrug:
Thanks to everyone's good input, I have a new one coming in tomorrow and will replace it.

Mick
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top