CF Freak II

Very nice. How much do they go for? I will email you my list later today....

HKFEVER said:

The attached picture is only trial fit, and need to improve the Cowling cover a little bit. The air vents seems A OK, and waiting for A117U6003F to arrive to have final fitting.

Click to expand...

THAT is beautiful.

I like the air vent covers. Will you post a picture when you get some Matte ones in?
How do they attach to the car? The vent covers and the binnacle cover?

Gorkoracing said:

I like the air vent covers. Will you post a picture when you get some Matte ones in?
How do they attach to the car? The vent covers and the binnacle cover?

Click to expand...

I won't make any matt version at this moment, as I try to make it like "F" car with all the air vents in glossy CF.

Just simply small drops of silicon glue will do fine. Or may be a old chowing gum as they just clip on perfectly.

Looking good bro.

Why the extra lip on the binnacle cover? the part along the dash... Never seen it done that way before.

I'm in for the middle air vents as soon as they're available (should be a nice touch to tie in with the CF A-Post trim and side sills).

Yeah I need all four vent covers - not two side and one integrated middle piece... but four separate covers. That and the door pulls from the first group buy -poke-

lotus_dp said:

Why the extra lip on the binnacle cover? the part along the dash... Never seen it done that way before.

Click to expand...

That's why I mentioned " need improve " in previous thread, the tech made the 2 extra wings without asking me.

wooow

To finish the CF cover bits, I am desperately seeking for a deployed steering wheel airbag. Anyone can help? I will reward him/her good....

I am thinking a CF cup holder. The car could use one, and it does not seem that complex.

doug_porsche said:

I am thinking a CF cup holder. The car could use one, and it does not seem that complex.

Click to expand...

I don't see any design is good enough for me Not even the OEM holder.

Wasn't there a version where somebody integrated a cupholder into the center console?

300hpMR2 said:

Wasn't there a version where somebody integrated a cupholder into the center console?

Click to expand...

Yeah, my version. I could send one to HK to pull a mold from.

300hpMR2 said:

Wasn't there a version where somebody integrated a cupholder into the center console?

Click to expand...

I like the one that someone originally did years ago that resided underneath the passenger seat when not being used and swung out against the side of the console (matching it's curves) when it was... I know that Chazz just made one out of plexiglass. It can't be that difficult