The Lotus Cars Community banner
1 - 9 of 9 Posts

·
Registered
Joined
·
2,933 Posts
Discussion Starter · #1 ·
Here's a must have item for your Lotus. A nice sturdy stand for your laptop.
Made from Birch plywood fully covered in low pile black carpet. Welded steel upright, powder coated with satin black. Unseen velcro and friction hold it in place.

Price is $125.00 shipped to lower 48 USA.

This item is labor intensive and heavy to ship.

Yes can can make your own with two pieces of wood an a 2x4.

Paypal is [email protected]
 

Attachments

·
Premium Member
Joined
·
3,041 Posts
Picture?

sorry...for some reason the picture did not load till I sent in my post...
 

·
Registered
Joined
·
4,176 Posts
Is it easily removable if you need the passenger space back?
You can remove or install in seconds...literally. Uses the pax seat for leverage and there are no screws, etc to the car. It's a very innovative design and you won't be disappointed.
 

·
Registered
Joined
·
2,206 Posts
Very nice!

I got my stand, thanks Jim!

It's very well built and a bargain at twice the price.

I had to modify mine a bit because I have non-stock seats and a fire extinguisher. It took about 15 minutes of measuring and modifying and it now fits like a glove. Two photos are attached showing it in my car.

Thanks again, Jim.

Joe
 

Attachments

·
Registered
Joined
·
2,933 Posts
Discussion Starter · #8 ·
Nice customization. Tight fit around the bracket. I had to cut mine too after installing the fire ext. Mine looks a bit rough after I got done.

Nice job!
 

·
Registered
Joined
·
2,206 Posts
Hi Jim,

I cut out a section 3" wide from the middle that extends 4" in. If yours was similar, maybe you should just make them that way in the future, since probably a lot of people have the fire extinguishers, and it should work fine for those who don't.

Thanks again,

Joe
 
1 - 9 of 9 Posts
Top