The Lotus Cars Community banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,317 Posts
Discussion Starter #1
Hey guys, not sure where to put this... i've had some engine work (surge tank) and other "stuff" done to the motor, and all is well and fine accept since then the fuel gage reads oddly after it gets much below 2 bars. From above 2 bars it's like it always was (i have about 70k on the car) but immediately after the install work it now drops from 1.5 bars to zero bars in the span of 5-10 miles. if i stop to filler' up, it lets me put 1-2 gallons in the car so i know it's reading falsely, and if i stop the car and re-start it, it'll read it has the 1.5-2 bars again, so "something" is resulting in the car thinking it's fuel is low.

Anybody seen this before?
 
1 - 2 of 2 Posts
Top