Going to drive an S2 on Saturday.
1 - 3 of 3 Posts
Joined
·
237 Posts
sounds great!
If the top is on! the best way to get in is to sit down on the door panel and tuck ur head in then slowly turn in wile at the same time falling thru to the seat. You should be fine.
Good luck! tell us how it went!
If the top is on! the best way to get in is to sit down on the door panel and tuck ur head in then slowly turn in wile at the same time falling thru to the seat. You should be fine.
Good luck! tell us how it went!
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Inokinetic short shift install notes
Powertrain (Engine, Transmission, etc)I am finishing up the install of the Inokinetic Ultimate shift package, which includes the Short shift linkage. While, for the most part, the directions/video provided by Inkinetic is accurate and helpful, I found the short shift linkage somewhat perplexing. This post describes in detail how to...- 0
- 225
-
wonk · updated
-
How many 2005 Owners with the BOE Torque200 tune have to crank a couple times to start?
Powertrain (Engine, Transmission, etc)I've noted before that I love the results of my Torque200 tune, but one of the drawbacks is the hard start. It takes 2-3 cranks before it now whimpers to a start. How many folks experience this same issue?- 8
- 1K
-
me73 · updated
-
Replace radiator step by step without disconnecting oil/refrig lines
Powertrain (Engine, Transmission, etc)Step by step of radiator removal. Hope this helps the next person in search for help on replacing there radiator. radiator replaced with proRAD from sector111 PDF format- 34
- 15K
-
bman6074 · updated
-
Vibration after installing Powerflex engine mount bushings
Powertrain (Engine, Transmission, etc)Since I had the engine mounts out while replacing my clutch, I went ahead and installed front and rear Powerflex engine mount bushings. I have a very noticable increase in vibration in the cabin at while idling. Vibration seems to go away above idle. It's bad enough I'm thinking of removing...- 8
- 1K
-
PeteB37 · updated
-
Built BOE Rev 400 engine only making 220 whp
Powertrain (Engine, Transmission, etc)Hi all, Did an engine swap a few months back into my 2006 Exige, engine built by BOE - 2ZZ w/ stage 3 cams, arias race pistons, nikasil cylinders. It is a used engine so I get that it's unknown, but according to the previous owner should have 1 season of competitive auto-x, 4 HPDE's and a couple...- 49
- 4K
-
Varun916 · updated
Join now to ask and comment!