The Lotus Cars Community banner

1 - 6 of 6 Posts

·
Registered
Joined
·
6,601 Posts
Discussion Starter #1
End product (one of six pieces) shown. These allow you to use the NCI/RLS Wide Scoops
on your Exige.

The parts start life as a round bar of 6061 aircraft aluminum.

Here it is running on the CNC turning center today:
http://www.youtube.com/embed/UuWQTXbKj3k

.
 

Attachments

·
6.94915254 lbs/hp
Joined
·
1,738 Posts
I stopped at by the RLS shop earlier today and man were those parts ridiculously light! In fact I was impressed with the quality, attention to detail and the amount of time that was spent on every part there!

It was fun watching the CNC machine at work too!
 

·
Registered
Joined
·
6,601 Posts
Discussion Starter #4
You just watched them being made! The 1st set is for you, I'll ship them out tomorrow morning. :)
 

·
Registered
Joined
·
6,601 Posts
Discussion Starter #6
I stopped at by the RLS shop earlier today and man were those parts ridiculously light! In fact I was impressed with the quality, attention to detail and the amount of time that was spent on every part there!

It was fun watching the CNC machine at work too!
It was great to meet you... when you didn't get that glazed look in your eyes, I realize that you must also be an engineer! :)
 
1 - 6 of 6 Posts
Top