The Lotus Cars Community banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,636 Posts
Discussion Starter · #1 ·
Does anyone know the part number that needs to be milled to increase the front camber? I believe it is the bearing housing but could be off. Anyone have a suggestion for a shop that can mill it accurately? I'm shooting for -1.5degrees up front. even after removing all shims and the abs sensor I can only get -0.8. It would vastly improve turn-in.
 

·
Registered
Joined
·
1,966 Posts


You can mill the suspension upright, which is also the bearing holder, labelled 1 in this picture, or the steering arm, labelled 4. Another way is to buy the Eliseparts bump-steer kit, which gives another couple degrees of negative camber: Elise Parts -  >  > Reduced Bump Steering Arm kit
 
1 - 2 of 2 Posts
Top