The Lotus Cars Community banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,848 Posts
Discussion Starter #1
Hey guys

I bought this years ago for an experiment. It was a mesh kit to replace the rear panel area which was formed with a nice perforated mesh. Lamborghini of Chicago used to fab these but I bought the last one they had. I did a rough cut in it to try to have it match up to a euro exhaust but never finished it. The hole is likely in the right place for a custom exhaust (driver's side cut, yes I know, I know). Comes with 3 pieces as shown, may make a good basis for a custom exhaust setup or a dual out above diffuser. $125 shipped
 

Attachments

·
Registered
Joined
·
1,848 Posts
Discussion Starter #3
Does the cut on the driver's side align with the eurogrill opening?
It does but the rear panel is different than the lotus euro panel so it does lay out exactly the same. I did cut it for my Larini which did match up. It’s feather light the whole thing is aluminum.
 

·
Registered
Joined
·
1,848 Posts
Discussion Starter #5
sold thanks
 
1 - 5 of 5 Posts
Top