The Lotus Cars Community banner
1 - 9 of 9 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
Hi everyone,

Just picked up a 2005 Lotus Elise this past weekend and am getting ready to do the 45,000 mile service on it. The dealer did not have any service history on it so I will be replacing all fluids (clutch, brake, coolant, transmission - except oil, that was done before it was picked up), replace air filter, replace accessory belt (anyone know the size for a bone stock 111R, I found two different sizes searching on the board here).

In addition, I will be taking the cover off and inspecting the cam for wear (can I reuse the gasket here or do you usually suggest using a new one).

If there anything else that I should do? Anything I should be aware of before going into this, tips/suggestions?

-Steve
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #5 ·
I did the same service when I got my car last year.

Bleeding the coolant after it's refilled is pretty annoying - a vacuum-fill coolant system ("airlift") will help a lot if you have one available to you.

Bleed the clutch before the brakes as it's the most distant extreme of the hydraulic system, then bleed the brakes in the normal order (farthest from cylinder to closest).

Transmission is easy as can be and the air filter is fiddly but straightforward as well. Be sure you have the filter lined up the right way or you'll spend a long time wondering why your airbox won't close.

I inspected my belt and opted to keep the stock one. The belt code is 060663 - options all the way from the $20 range to a $70 super-fancy Gates belt that people seem to like (check out this post http://www.lotustalk.com/forums/2618450-post3.html). The tensioner is the silly "fake bolt" kind and they strip or break easily, so use a good 19mm 6-point socket and turn carefully.
Thanks for the suggestion around the Airlift, I will probably pick one up to save myself the headache, should also be helpful with my other cars.
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #7 ·
Check to see if your car had its oil line fittings replaced as per the Lotus recall.

If your Lotus tech is really getting in there you should consider replacing the thermostat. It's hard to reach and a PITA to do on your own.
I will be doing just about all of the work myself. As far as replacing the thermostat, I drove the car a bit this past weekend with temps in the 40-50 range. The car never went above 186F, does that sound about right?
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #12 ·
So I did a full service to the car last weekend.

Inspected cam (light scratches but nothing caught the fingernail, car has 45K+ on it so I am not too worried, or should I be?)
Replaced Lift Cam bolts
Replaced Spark Plugs
Replaced Accessory Belt
Replaced Air Filter
Replaced Coolant
Bleed Brakes/Clutch
Replaced Transmission Oil
Checked Rear Toe Link Torque


My question comes around the brake fluid reservoir. When bleeding the clutch and the brakes it seems that only the right side was being emptied. I know that the reservoir is baffled but it looks as if nothing from the other side was being removed. The right side shows clearer (I know I need to do this again as all of the old fluid was not removed, it was quite dark). My question is, is this normal? I am going to get a pressure bleeder and do this again, is the trick to just keep on adding and removing fluid and eventually the left side will be replaced by good fluid?

Water Tire Vehicle Auto part Car
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #14 ·
So I hooked up a pressure bleeder to just keep bleeding and bleeding and bleeding.

Here are the results of what came out. Looks as if the previous owner never changed the fluid. :facepalm

Canning Plastic


Edit: Don't know why it came in upside down, but you can see the color.
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #16 ·
Off topic, but sure!

Here is my car that was featured in an online article.

Unearthed: 1981 DeLorean DMC-12

Since then, I have done alot of upgrades, but not visual ones (different radio, lowered the front, powder coated engine and some other stuff). I really am over due for taking more recent photos. These are over 3 years old.
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #18 ·
Cool. Nice to see how well the stainless steel has held up. Thanks!
That stainless steel was sitting outside in a field in Georgia for 15 years before I got the car. All I did was clean it really well and go over it with a blending pad.
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #19 ·
Back on Lotus topic. I put a rubber hose over the U-pipe in the engine bay as it was starting to wear through. I saw the fix on another thread. Any idea what that piece is actually for?
 
1 - 9 of 9 Posts
Top