Joined
·
593 Posts
I thought I would pass this tip on to all who are runnning there radar detector wire up the side pillar, then acroos to the middle of the windshield.
I found the casing of coax cable to help fill in the gap. Keeping it from falling out. I used 4 pieces of coax. 1 in the corner, 1 where the wire comeout of the dash to the pilar, and 2 across the top part of the windshield.
Hope this was imformative.
Here are pics of steps.
Cut casing off coax.
slice the casing open
wrap the casing around your radar detector wire
Insert wire into car inbetween windshield and pillar.
I found the casing of coax cable to help fill in the gap. Keeping it from falling out. I used 4 pieces of coax. 1 in the corner, 1 where the wire comeout of the dash to the pilar, and 2 across the top part of the windshield.
Hope this was imformative.
Here are pics of steps.
Cut casing off coax.
slice the casing open
wrap the casing around your radar detector wire
Insert wire into car inbetween windshield and pillar.