The Lotus Cars Community banner
1 - 1 of 1 Posts

·
Registered
Joined
·
276 Posts
would be a lot easier to put the wheel in a manual lathe and open the bore radius .040." should be a simple job.... assuming you can fit the wheel to the lathe.
That would have to be a large lathe, around a 20-22 inch gate or so, larger than most shop lathes. A typical shop milling machine with an adjustable offset boring bar would do it well provided it was properly centered first.

As was mentioned earlier, it's got to be perfectly centric otherwise you'll feel it going down the road....
 
1 - 1 of 1 Posts
Top