The Lotus Cars Community banner

1 - 3 of 3 Posts

·
Registered
Joined
·
549 Posts
Discussion Starter #1
Last week Skip of Protective Film Technologies (Northern Virginia) did the front film install (details under separate thread)...came back today to do the rocker panel film install...and he wanted to inspect the status of the work he did the prior week...did not like one little (I mean little) spot on film and he corrected...very much the perfectionist :clap:

Anyway, he wanted to keep the factory install 12 mil film on the front of the rear fender flare in place (he did advise that the 12 mil film will slightly yellow over time..of course on Ellen's SY Elise no big deal...you all with silver and contrasting colors might notice something) so he came back to do a 'custom install on the rocker panels where he trimmed the Xpel pattern to fit around factory film and also go slightly higher on rear fender that factory film...as usual a great job :bow:
First pic shows the film just being set on car...again amazing the film can be work to 'disappear'



In this second pic I have place a red < to show where film starts and also how high it goes up the rear fender... also look closely and you can see the factory piece that he patterned around...



and yes he will visit back the 3rd time just to make sure all is well with the film.

If interested his web site is>>>>
Protective Film Technologies


A yellow Elise will be appearing on his website ;)
 

·
Registered
Joined
·
549 Posts
Discussion Starter #3
The factory piece at that location>>

being a 'high abuse' area is 12 mil thick...the Xpel film is 8 mil thick so he advised to leave factory on for extra protection...
 
1 - 3 of 3 Posts
Top